# Pool Builder & Pool Remodeling in Culver City, CA [Browser-friendly HTML version](https://www.remodelyourvibe.com/website-guide/pages/services/swimming-pool-spa/culver-city/index) Source: https://www.remodelyourvibe.com/services/swimming-pool-spa/culver-city Last modified: 2026-09-24T00:00:00.000Z Text part: 1 of 1 [Full website text index](https://www.remodelyourvibe.com/llms-full.txt) | [Services by city](https://www.remodelyourvibe.com/llms/services-by-city-001.txt) | [Previous page](https://www.remodelyourvibe.com/llms/pages/services/swimming-pool-spa/west-hollywood/index.txt) | [Next page](https://www.remodelyourvibe.com/llms/pages/services/swimming-pool-spa/venice/index.txt) --- Image: Pool with a fire table, lounge chairs and paver decking set in turf at sunset 1. [Home](https://www.remodelyourvibe.com/) 1. [Services](https://www.remodelyourvibe.com/services) 1. [Swimming Pool & Spa](https://www.remodelyourvibe.com/services/swimming-pool-spa) 1. Culver City Design · Permit · Build ### Pool & Spa Remodeling in Culver City We build new pools and spas, and remodel the ones already in the ground. [Book a Consultation](https://www.remodelyourvibe.com/contact-us) [Call 818-300-2393](tel:+18183002393) #### Built for Culver City Homes This is a city that rewards careful groundwork. Parts of the flatland near Ballona Creek are mapped for liquefaction, so pool shells and ADU foundations there can need engineering that a similar house a few miles inland would never require. Up in the Baldwin Hills pockets, slopes and steep driveways change how we get concrete and equipment onto a site. We also confirm early whether a parcel sits near the Inglewood Oil Field, which the city is phasing out. Mostly flat, uniform post-war tract lots with detached garages and modest rear yards, plus a smaller set of sloped hillside parcels on the Baldwin Hills side. We are a design-build team, which means the people who draw your project are the people who build it. Design, engineering, permits and construction run through one project manager and our own crews, so nothing gets lost in a handoff between a salesperson and a subcontractor. We are licensed, bonded and insured, [CSLB license #1119054](https://www.cslb.ca.gov/OnlineServices/CheckLicenseII/LicenseDetail.aspx?LicNum=1119054) . Permits in Culver City: Permits are issued by the city's own Building Safety Division on Culver Boulevard, with applications and inspections handled through the city's online Accela portal rather than through Los Angeles. Portions of the low-lying city fall within state-mapped seismic hazard liquefaction zones, so a site-specific geotechnical investigation can be required for new construction in those zones. Parcels in the Baldwin Hills sit near the Inglewood Oil Field, part of which lies within city limits, and the city adopted an oil termination ordinance addressing nonconforming oil use. The city also administers its own zoning code and historic preservation program independently of the surrounding city and county. Permit details checked September 2026 against [City of Culver City](https://www.culvercity.gov/City-Hall/City-Departments/Planning-Development-Department/Building-Safety) , [State of California](https://www.conservation.ca.gov/cgs/Documents/Publications/SHZR/SHZR_036_Venice.pdf) and [Culver City Municipal Code](https://codelibrary.amlegal.com/codes/culvercity/latest/culvercity_ca/0-0-0-44515) . Rules change, so we confirm them again for your parcel. What We Build - Liquefaction-zone structural design - Detached ADU and garage conversion permitting - New gunite pool and spa construction - Full pool remodels and replastering - Pebble, quartz and plaster interior finishes - Waterline tile and coping replacement - Raised and attached spas with spillways - Baja shelves, benches and sun ledges - Water features, fire bowls and sheer descents - Equipment upgrades, heaters and automation - Pool decking in pavers, concrete or travertine - LED lighting and salt-water conversions Local Conditions #### What to Know in Culver City These local conditions change the scope, the schedule and the budget. 01 Low-lying ground near the creek corridor is mapped in a state seismic hazard liquefaction zone, which can bring a geotechnical investigation and heavier reinforcement for pool shells and ADU slabs. 02 Hillside pockets above the flats have steep driveways and tight turning room that restrict concrete truck and crane access. 03 Post-war tract houses commonly still run 100-amp services and cast-iron drain lines that need replacement before new outdoor loads and fixtures are added. 04 Typical mid-size tract lots leave shallow rear yards, so pool, spa, equipment enclosure and shade structure all compete for the same setback envelope. Areas we serve in Culver City:Carlson ParkSunkist ParkBlair HillsCulver CrestFox HillsStudio Village Investment #### What It Costs in Culver City Real Southern California price ranges, not teaser numbers. ##### New pool construction $70,000 to $150,000+ What moves it: size and shape, spa, water and fire features, decking material, automation, and how much access and grading the site needs ##### Pool remodel and resurfacing $15,000 to $45,000 What moves it: finish choice (plaster versus pebble or quartz), tile and coping replacement, new equipment, and whether the deck is being replaced at the same time ##### Paver patio and hardscape from about $13,000 What moves it: square footage, paver type, base preparation, drainage, and any steps or retaining involved Your lot, access and finishes set the price. We walk the site, then show you where every dollar goes. [Get a line-item price for your Culver City property](https://www.remodelyourvibe.com/contact-us) The Process #### How We Work in Culver City 01 ##### Site Review We walk the property, check access, soil and slope, and confirm what the yard can actually take. 02 ##### Design & 3D You see the pool in 3D before anything is dug, with finishes, tile and decking chosen. 03 ##### Plans & Permits We draw the plans, handle engineering where the site needs it, and pull the permits. In Culver City that submittal goes to City of Culver City Building Safety Division (Planning and Development Department). 04 ##### Excavation & Shell Dig, steel, plumbing and gunite. This is where site access and grading matter most. 05 ##### Finishes Tile, coping, decking and your chosen interior finish go in. 06 ##### Startup & Handover We fill, balance the water, commission the equipment and walk you through every control. Questions #### What Culver City Homeowners Ask Who issues the permits for this work in Culver City? City of Culver City Building Safety Division (Planning and Development Department). Permits are issued by the city's own Building Safety Division on Culver Boulevard, with applications and inspections handled through the city's online Accela portal rather than through Los Angeles. Portions of the low-lying city fall within state-mapped seismic hazard liquefaction zones, so a site-specific geotechnical investigation can be required for new construction in those zones. Parcels in the Baldwin Hills sit near the Inglewood Oil Field, part of which lies within city limits, and the city adopted an oil termination ordinance addressing nonconforming oil use. The city also administers its own zoning code and historic preservation program independently of the surrounding city and county. We prepare the drawings, make the submittal and handle plan-check corrections ourselves, so you are not the one chasing plan check. What makes building in Culver City different? Mostly flat, uniform post-war tract lots with detached garages and modest rear yards, plus a smaller set of sloped hillside parcels on the Baldwin Hills side. One local condition that shapes the work: Low-lying ground near the creek corridor is mapped in a state seismic hazard liquefaction zone, which can bring a geotechnical investigation and heavier reinforcement for pool shells and ADU slabs. Which parts of Culver City do you work in? All of it, including Carlson Park, Sunkist Park, Blair Hills and Culver Crest. Our crews run every job out of our Cahuenga Pass base in Los Angeles, with our own people on site. What does a pool or spa project cost in Culver City? New pool construction: generally $70,000 to $150,000+ across Southern California. What moves it is size and shape, spa, water and fire features, decking material, automation, and how much access and grading the site needs. We give line-item pricing after seeing the site rather than quoting a number over the phone. How long does a pool remodel take? A straightforward replaster with new tile and coping usually runs three to five weeks. A full remodel that includes new decking, equipment and features typically runs eight to twelve weeks. Site access and permit timing are the two things that move that most. How long does a new pool take to build? Most new pool builds run about three to five months from permit to first swim. Hillside sites that need engineered retaining or difficult access sit at the longer end of that range. Should I replaster or fully remodel? If the shell and plumbing are sound and you only dislike the surface, replastering with new tile and coping is the efficient choice. If the equipment is aging, the deck is cracked or the shape no longer suits how you use the yard, a full remodel costs less than doing it in two separate phases. Do you self-perform the work? Yes. Our own crews handle the build rather than passing it to a rotating set of subs, which is why the schedule and the finish standard stay consistent. #### More Services in Culver City [Backyard & Outdoor Living in Culver City](https://www.remodelyourvibe.com/services/exterior-remodeling/culver-city) [ADUs & Additions in Culver City](https://www.remodelyourvibe.com/services/adus-additions/culver-city) [Everything we build in Culver City](https://www.remodelyourvibe.com/service-areas/culver-city) #### Pool & Spa Remodeling Nearby [Pool & Spa Remodeling in Los Angeles](https://www.remodelyourvibe.com/services/swimming-pool-spa/los-angeles) [Pool & Spa Remodeling in Venice](https://www.remodelyourvibe.com/services/swimming-pool-spa/venice) [Pool & Spa Remodeling in Santa Monica](https://www.remodelyourvibe.com/services/swimming-pool-spa/santa-monica) [Pool & Spa Remodeling in West Hollywood](https://www.remodelyourvibe.com/services/swimming-pool-spa/west-hollywood) [Pool & Spa Remodeling in Mar Vista](https://www.remodelyourvibe.com/services/swimming-pool-spa/mar-vista) [Pool & Spa Remodeling in Cheviot Hills](https://www.remodelyourvibe.com/services/swimming-pool-spa/cheviot-hills) Planning Guides #### Before You Build in Culver City Costs, materials and process notes from our own projects. [Building a Pool in Northridge: Costs and Permits A new pool in Northridge typically runs $85,000 to $165,000 all-in with decking and equipment. The tract lots are generous, the soil is workable, and the real variables are access, spa and deck square footage. Read guide](https://www.remodelyourvibe.com/articles/northridge-pool-building-guide) [Van Nuys Pool and Backyard Costs A new pool in Van Nuys runs $75,000 to $145,000, and a pool-plus-backyard package $110,000 to $220,000. Flat lots keep excavation honest; older service panels and gas meters are where budgets slip. Read guide](https://www.remodelyourvibe.com/articles/van-nuys-pool-and-backyard-guide) [Travertine vs Porcelain Pavers for SoCal Yards Travertine installs at roughly $22 to $30 per square foot, porcelain at $24 to $34. The real difference is heat, staining and how each one handles a chlorinated pool deck over ten years. Read guide](https://www.remodelyourvibe.com/articles/travertine-vs-porcelain-pavers-southern-california) [Pool Coping Options: Concrete, Stone and Porcelain Coping runs $28 to $55 per lineal foot in concrete, $55 to $110 in natural stone and $60 to $120 in porcelain. On an average pool perimeter that is a $2,500 to $11,000 decision. Read guide](https://www.remodelyourvibe.com/articles/pool-coping-options-concrete-stone-porcelain) #### Planning a Pool in Culver City? Sit down with your project manager and get an accurate estimate. We call you back within one business day. [Book a Consultation](https://www.remodelyourvibe.com/contact-us) [818-300-2393](tel:+18183002393) Licensed, bonded & insured · [CSLB license #1119054](https://www.cslb.ca.gov/OnlineServices/CheckLicenseII/LicenseDetail.aspx?LicNum=1119054) --- End of text part 1 of 1. This page is complete.