Skip to main content
Covered patio with a linear fire table and lounge seating
Design · Permit · Build

Patio Cover & Pergola Contractor in Irvine

Patio covers and pergolas, engineered, permitted and built by our own crews.

Licensed contractor
California general contractor, CSLB #1119054. Bonded and insured.
Typical cost
Pergola and shade structure: from about $9,500.
Permits
Issued by the City of Irvine. We handle the plans and the submittal.

Built for Irvine Homes

Two approvals, not one: that is the rhythm of working in a master-planned city. The village association's architectural committee cares about roof material, stucco color and how a pool equipment enclosure reads from the common area; the city cares about code, setbacks and drainage into an engineered storm system.

We prepare both submittals in parallel, and we design to the approved exterior palette rather than fighting it.

Lots are planned and predictable: rectangular pads with consistent setbacks, walled rear yards and a defined side yard. Newer villages trend toward smaller usable rear yards with larger homes, while the older established villages and the custom enclaves offer genuinely deep backyards.

What to Plan For

A patio cover is a structure, and it is designed like one. Attached to the house, it has to tie into the existing framing properly. Freestanding, it stands on its own footings. Either way the span, the posts and the footings are sized for the roof it carries, and that is what a building department reviews.

The roof decides how the space gets used. An open pergola filters the sun and keeps the sky. A solid roof gives real shade and shelter from rain. A louvered roof opens and closes, so you can have both. Wood, aluminum and steel each look and age differently, and we show you the options in 3D against your own house.

It is rarely built alone. Lighting, fans and heaters need power run to the structure, and the patio underneath often gets rebuilt at the same time. Planning them as one project means the posts land where the paving and the furniture want them.

We are a design-build team, which means the people who draw your project are the people who build it. Design, engineering, permits and construction run through one project manager and our own crews, so nothing gets lost in a handoff between a salesperson and a subcontractor. We are licensed, bonded and insured, CSLB license #1119054.

Permits in Irvine: Plan review, permit issuance and inspections are handled by the Building and Safety Division within the Community Development Department, with submittals and inspection scheduling through the city's online permits system. Some minor residential replacements are available as self-service permits, while pools, spas, additions and ADUs require full plan check.

Permits for Group R-3 residential work become invalid eighteen months from issuance unless extended in writing by the Building Official. Essentially every village is governed by a master association and often a sub-association as well, and the architectural review committee runs on its own separate track from city plan check.

Under state law an association cannot ban an ADU outright, but it can enforce reasonable exterior standards for materials, color and placement.

Permit details checked September 2026 against City of Irvine and California law. Rules change, so we confirm them again for your parcel.

What We Build

  • Parallel HOA architectural review packages
  • Slope and landscape easement mapping
  • Engineered drainage tie-in design
  • Attached patio covers
  • Freestanding pergolas and pavilions
  • Louvered roof systems
  • Solid roof covers
  • Wood, aluminum and steel structures
  • Engineered posts, beams and footings
  • Lighting, fans and heaters, wired in
  • Covers over outdoor kitchens and dining
  • Paver or concrete patios beneath
  • Plans, engineering and permits

Local Conditions

What to Know in Irvine

These local conditions change the scope, the schedule and the budget.

01

Rear yards back onto engineered slopes and association-maintained landscape easements far more often than onto neighboring property, which limits where a shell or foundation can legally sit.

02

Pads in the newer villages are cut-and-fill over expansive clay, so deepened footings and moisture-conditioned subgrade are common requirements on pool decks and casita slabs.

03

Site drainage is tied into a designed storm system with defined outlet points, so new hardscape has to be routed to an approved discharge rather than sheet-flowed toward a neighbor.

04

Side yards in the tighter tract product can be narrow, which may force hand-dig, conveyor or crane access for backyard excavation.

Areas we serve in Irvine:Turtle RockWoodbridgeNorthwoodShady CanyonQuail HillOrchard Hills

Investment

What It Costs in Irvine

Real Southern California price ranges, not teaser numbers.

Pergola and shade structure

from about $9,500

What moves it: span, material (wood, aluminum or louvered), footing requirements, and integrated lighting or heating

Paver patio and hardscape

from about $13,000

What moves it: square footage, paver type, base preparation, drainage, and any steps or retaining involved

Landscape and architectural lighting

$3,000 to $12,000

What moves it: number of fixtures, transformer and cable runs, fixture quality, and whether the system is put on smart control

Your lot, access and finishes set the price. We walk the site, then show you where every dollar goes.

Get a line-item price for your Irvine property

The Process

How We Work in Irvine

01

Site Review

We measure the patio and the house, check where posts and footings can go, and note sun and sight lines.

02

Design & 3D

You see the cover in 3D on your own house, open, solid or louvered, in the material you choose.

03

Plans & Permits

The structure is drawn and engineered, and submitted for a permit where your city requires one. In Irvine that submittal goes to City of Irvine Community Development Department, Building and Safety Division.

04

Footings & Posts

Footings are dug and poured, then posts are set plumb and anchored.

05

Frame & Roof

Beams, rafters and the roof system go on, with power run for lighting, fans and heaters.

06

Finish & Handover

Stain, paint or powder coat, final electrical, inspection where one applies, and a walkthrough.

Questions

What Irvine Homeowners Ask

Who issues the permits for this work in Irvine?

City of Irvine Community Development Department, Building and Safety Division. Plan review, permit issuance and inspections are handled by the Building and Safety Division within the Community Development Department, with submittals and inspection scheduling through the city's online permits system.

Some minor residential replacements are available as self-service permits, while pools, spas, additions and ADUs require full plan check. Permits for Group R-3 residential work become invalid eighteen months from issuance unless extended in writing by the Building Official.

Essentially every village is governed by a master association and often a sub-association as well, and the architectural review committee runs on its own separate track from city plan check. Under state law an association cannot ban an ADU outright, but it can enforce reasonable exterior standards for materials, color and placement.

We prepare the drawings, make the submittal and handle plan-check corrections ourselves, so you are not the one chasing plan check.

What makes building in Irvine different?

Lots are planned and predictable: rectangular pads with consistent setbacks, walled rear yards and a defined side yard. Newer villages trend toward smaller usable rear yards with larger homes, while the older established villages and the custom enclaves offer genuinely deep backyards.

One local condition that shapes the work: Rear yards back onto engineered slopes and association-maintained landscape easements far more often than onto neighboring property, which limits where a shell or foundation can legally sit.

Which parts of Irvine do you work in?

All of it, including Turtle Rock, Woodbridge, Northwood and Shady Canyon. Our crews run every job out of our Cahuenga Pass base in Los Angeles, with our own people on site.

What does a patio cover or pergola cost in Irvine?

Pergola and shade structure: generally from about $9,500 across Southern California. What moves it is span, material (wood, aluminum or louvered), footing requirements, and integrated lighting or heating. We give line-item pricing after seeing the site rather than quoting a number over the phone.

Do I need a permit for a patio cover or pergola?

Usually yes for a cover attached to the house or one with a solid roof. Small freestanding pergolas are treated differently from city to city, and adding electrical brings its own permit. We check the rule with your building department before we price the job.

Wood, aluminum or a louvered roof?

Wood is warm and can be shaped to match almost any house, and it needs refinishing over the years. Aluminum needs very little upkeep and suits a clean, modern look. A louvered roof costs more and lets you open the space to the sky or close it for shade and rain.

Can it have lights, a fan and heaters?

Yes. They are far cleaner to add when they are planned, because the wiring runs inside the posts and beams. Adding them later usually means surface conduit.

How long does a patio cover take?

The build itself is short compared with the planning. Engineering and the plan review in your city usually set the schedule, so we give you a real timeline once we know which review your project needs.

Planning a Patio Cover in Irvine?

Sit down with your project manager and get an accurate estimate. We call you back within one business day.

Licensed, bonded & insured · CSLB license #1119054