Skip to main content
Covered patio with a linear fire table and lounge seating
Design · Permit · Build

Patio Cover & Pergola Contractor in Newport Beach

Patio covers and pergolas, engineered, permitted and built by our own crews.

Licensed contractor
California general contractor, CSLB #1119054. Bonded and insured.
Typical cost
Pergola and shade structure: from about $9,500.
Permits
Issued by the City of Newport Beach. We handle the plans and the submittal.

Built for Newport Beach Homes

Almost everything we build here is shaped by water: the harbor, the water table, and the salt in the air. A pool on Balboa Island starts as a groundwater question before it becomes a design problem, while a Newport Coast backyard is a slope and HOA-palette problem.

We plan coastal review, alley access and crane staging early, because on a thirty-foot-wide lot the logistics decide the design.

Lot character swings hard between narrow, deep alley-served parcels on the islands and peninsula and larger graded hillside pads in Newport Coast and the bluff tracts. Rear yards on the older lots are compact and almost always accessed through a side gate or alley rather than a driveway.

What to Plan For

A patio cover is a structure, and it is designed like one. Attached to the house, it has to tie into the existing framing properly. Freestanding, it stands on its own footings. Either way the span, the posts and the footings are sized for the roof it carries, and that is what a building department reviews.

The roof decides how the space gets used. An open pergola filters the sun and keeps the sky. A solid roof gives real shade and shelter from rain. A louvered roof opens and closes, so you can have both. Wood, aluminum and steel each look and age differently, and we show you the options in 3D against your own house.

It is rarely built alone. Lighting, fans and heaters need power run to the structure, and the patio underneath often gets rebuilt at the same time. Planning them as one project means the posts land where the paving and the furniture want them.

We are a design-build team, which means the people who draw your project are the people who build it. Design, engineering, permits and construction run through one project manager and our own crews, so nothing gets lost in a handoff between a salesperson and a subcontractor. We are licensed, bonded and insured, CSLB license #1119054.

Permits in Newport Beach: Residential plan check, permits and inspections run through the Building Division permit counter at the Civic Center on Civic Center Drive. Most harbor, island, peninsula and bluff property sits inside the Coastal Zone, and the city has issued its own Coastal Development Permits since its Local Coastal Program Implementation Plan took effect on January 30, 2017; certain geographic areas and project types remain appealable to the California Coastal Commission.

Dock and pier construction permits for work bayward of the bulkhead are processed separately by the Public Works Department, not the Building Division. Newport Coast and several bluff and island communities layer HOA architectural review on top of city review, and setback encroachments typically require a Modification Permit.

Permit details checked September 2026 against City of Newport Beach and Newport Beach Municipal Code. Rules change, so we confirm them again for your parcel.

What We Build

  • Coastal Development Permit coordination
  • Dewatering and hydrostatic pool design
  • Marine-grade corrosion detailing
  • Attached patio covers
  • Freestanding pergolas and pavilions
  • Louvered roof systems
  • Solid roof covers
  • Wood, aluminum and steel structures
  • Engineered posts, beams and footings
  • Lighting, fans and heaters, wired in
  • Covers over outdoor kitchens and dining
  • Paver or concrete patios beneath
  • Plans, engineering and permits

Local Conditions

What to Know in Newport Beach

These local conditions change the scope, the schedule and the budget.

01

Groundwater can be shallow on the islands and the peninsula, so the geotechnical report may call for dewatering during pool and spa excavation and hydrostatic relief in the finished shell. Dewatering discharge is regulated.

02

Salt-laden air accelerates corrosion on equipment pads, fasteners, railings and outdoor kitchen appliances, which pushes specifications toward marine-grade stainless, powder-coated aluminum and sealed enclosures.

03

Alley-loaded lots roughly thirty feet wide leave no room for a dozer or a full-size dump truck, so excavation is frequently conveyor, mini-excavator and street-permit staging work.

04

Bluff and coastal canyon parcels carry geotechnical stability setbacks that can move a pool or structure well inboard of the property line.

Areas we serve in Newport Beach:Corona del MarBalboa IslandBalboa PeninsulaNewport CoastLido IsleDover Shores

Investment

What It Costs in Newport Beach

Real Southern California price ranges, not teaser numbers.

Pergola and shade structure

from about $9,500

What moves it: span, material (wood, aluminum or louvered), footing requirements, and integrated lighting or heating

Paver patio and hardscape

from about $13,000

What moves it: square footage, paver type, base preparation, drainage, and any steps or retaining involved

Landscape and architectural lighting

$3,000 to $12,000

What moves it: number of fixtures, transformer and cable runs, fixture quality, and whether the system is put on smart control

Your lot, access and finishes set the price. We walk the site, then show you where every dollar goes.

Get a line-item price for your Newport Beach property

The Process

How We Work in Newport Beach

01

Site Review

We measure the patio and the house, check where posts and footings can go, and note sun and sight lines.

02

Design & 3D

You see the cover in 3D on your own house, open, solid or louvered, in the material you choose.

03

Plans & Permits

The structure is drawn and engineered, and submitted for a permit where your city requires one. In Newport Beach that submittal goes to City of Newport Beach Community Development Department, Building Division.

04

Footings & Posts

Footings are dug and poured, then posts are set plumb and anchored.

05

Frame & Roof

Beams, rafters and the roof system go on, with power run for lighting, fans and heaters.

06

Finish & Handover

Stain, paint or powder coat, final electrical, inspection where one applies, and a walkthrough.

Questions

What Newport Beach Homeowners Ask

Who issues the permits for this work in Newport Beach?

City of Newport Beach Community Development Department, Building Division. Residential plan check, permits and inspections run through the Building Division permit counter at the Civic Center on Civic Center Drive. Most harbor, island, peninsula and bluff property sits inside the Coastal Zone, and the city has issued its own Coastal Development Permits since its Local Coastal Program Implementation Plan took effect on January 30, 2017; certain geographic areas and project types remain appealable to the California Coastal Commission.

Dock and pier construction permits for work bayward of the bulkhead are processed separately by the Public Works Department, not the Building Division. Newport Coast and several bluff and island communities layer HOA architectural review on top of city review, and setback encroachments typically require a Modification Permit.

We prepare the drawings, make the submittal and handle plan-check corrections ourselves, so you are not the one chasing plan check.

What makes building in Newport Beach different?

Lot character swings hard between narrow, deep alley-served parcels on the islands and peninsula and larger graded hillside pads in Newport Coast and the bluff tracts. Rear yards on the older lots are compact and almost always accessed through a side gate or alley rather than a driveway.

One local condition that shapes the work: Groundwater can be shallow on the islands and the peninsula, so the geotechnical report may call for dewatering during pool and spa excavation and hydrostatic relief in the finished shell. Dewatering discharge is regulated.

Which parts of Newport Beach do you work in?

All of it, including Corona del Mar, Balboa Island, Balboa Peninsula and Newport Coast. Our crews run every job out of our Cahuenga Pass base in Los Angeles, with our own people on site.

What does a patio cover or pergola cost in Newport Beach?

Pergola and shade structure: generally from about $9,500 across Southern California. What moves it is span, material (wood, aluminum or louvered), footing requirements, and integrated lighting or heating. We give line-item pricing after seeing the site rather than quoting a number over the phone.

Do I need a permit for a patio cover or pergola?

Usually yes for a cover attached to the house or one with a solid roof. Small freestanding pergolas are treated differently from city to city, and adding electrical brings its own permit. We check the rule with your building department before we price the job.

Wood, aluminum or a louvered roof?

Wood is warm and can be shaped to match almost any house, and it needs refinishing over the years. Aluminum needs very little upkeep and suits a clean, modern look. A louvered roof costs more and lets you open the space to the sky or close it for shade and rain.

Can it have lights, a fan and heaters?

Yes. They are far cleaner to add when they are planned, because the wiring runs inside the posts and beams. Adding them later usually means surface conduit.

How long does a patio cover take?

The build itself is short compared with the planning. Engineering and the plan review in your city usually set the schedule, so we give you a real timeline once we know which review your project needs.

Planning a Patio Cover in Newport Beach?

Sit down with your project manager and get an accurate estimate. We call you back within one business day.

Licensed, bonded & insured · CSLB license #1119054