
Paver & Hardscape Contractor in Thousand Oaks
Paver patios, driveways and walls, built on a proper base by our own crews.
- Licensed contractor
- California general contractor, CSLB #1119054. Bonded and insured.
- Typical cost
- Paver patio and hardscape: from about $13,000.
- Permits
- Issued by the City of Thousand Oaks. We handle the plans and the submittal.
Built for Thousand Oaks Homes
Conejo Valley work starts with a tree survey. Protected oaks here include any Quercus over two inches in diameter, and the protected zone runs five feet past the canopy edge or fifteen feet from the trunk, whichever is larger. That single rule decides where a pool, a cabana or an ADU pad can go.
Add ridgeline and hillside overlays on the upper parcels, and siting becomes the real design problem, not styling.
A wide range, from flat suburban parcels with generous rear yards in the older tracts to larger hillside and gated-community lots with slope, oaks and protected view corridors in North Ranch, Sunset Hills and Dos Vientos.
What to Plan For
Pavers last when the base is right. What you see is the top two or three inches. Underneath is excavation to the correct depth, a compacted base, a setting bed and an edge restraint that stops the field from spreading. That work is where a paver job is won or lost, and it is the part a low bid leaves out.
Water comes next. Hardscape changes where rain goes, so we set the slopes and add drains while the ground is open. Fixing drainage after the pavers are down means lifting them again.
The material is your choice. Concrete pavers, porcelain and natural stone such as travertine differ in look, in how hot they get underfoot and in price. A driveway needs a thicker paver and a deeper base than a patio. We bring samples and show the layout in 3D, so the pattern and the borders are settled before we order.
We are a design-build team, which means the people who draw your project are the people who build it. Design, engineering, permits and construction run through one project manager and our own crews, so nothing gets lost in a handoff between a salesperson and a subcontractor. We are licensed, bonded and insured, CSLB license #1119054.
Permits in Thousand Oaks: Residential permits are issued by the Building Division of the City's Community Development Department. Thousand Oaks protects all Quercus species over two inches in diameter, and the protected zone reaches five feet beyond the outer canopy or fifteen feet from the trunk, whichever is greater, so work or soil disturbance inside that zone requires an oak tree permit.
Hillside Planned Development zoning and the Protected Ridgeline and Height Limit overlay zones apply area by area and add grading, siting and visual-analysis requirements. Review length varies with the extent of tree and grading review a project triggers.
Permit details checked September 2026 against City of Thousand Oaks and Thousand Oaks Municipal Code. Rules change, so we confirm them again for your parcel.
What We Build
- Oak tree permit and arborist coordination
- Rock excavation planning for pools
- Ridgeline and hillside overlay compliance
- Paver patios and pool decks
- Paver driveways and walkways
- Concrete, porcelain and natural stone pavers
- Excavation, compacted base and edge restraint
- Drainage correction and grading
- Retaining walls and seat walls
- Steps, landings and planters
- Fire pits with built-in seating
- Artificial turf and turf joints
- Low-voltage hardscape lighting
Local Conditions
What to Know in Thousand Oaks
These local conditions change the scope, the schedule and the budget.
Volcanic and sedimentary bedrock sits close to grade on many hillside parcels, so pool and spa excavation can become rock removal with a very different cost and schedule.
Oak canopies frequently cover the most usable part of a rear yard, forcing pier-supported decks and permeable surfaces instead of conventional slabs.
Open-space-adjacent parcels carry defensible-space and fuel-modification obligations that limit planting and structure placement near the rear property line.
Slope and ridgeline overlays constrain height and pad grading, which usually pushes outdoor living down into terraced levels rather than one large platform.
Investment
What It Costs in Thousand Oaks
Real Southern California price ranges, not teaser numbers.
Paver patio and hardscape
from about $13,000
What moves it: square footage, paver type, base preparation, drainage, and any steps or retaining involved
Retaining walls
$60 to $150 per face foot
What moves it: height, whether the wall is engineered, material choice, drainage behind the wall, and access for equipment and materials
Artificial turf
from about $9,900
What moves it: area, turf grade, base depth, drainage, and any pet-specific infill
Your lot, access and finishes set the price. We walk the site, then show you where every dollar goes.
Get a line-item price for your Thousand Oaks propertyThe Process
How We Work in Thousand Oaks
Site Review
We measure the area, check soil, slope and drainage, and note access for equipment and materials.
Design & 3D
You see the layout, pattern, borders and material in 3D before anything is ordered.
Plans & Permits
Walls, driveway approaches and drainage work are drawn and permitted where your city requires it. In Thousand Oaks that submittal goes to City of Thousand Oaks Community Development Department, Building Division.
Demo & Excavation
Old concrete comes out and the area is dug to the depth the new base needs.
Base & Pavers
Base is placed and compacted in layers, then the setting bed, pavers, cuts and edge restraint.
Joints & Handover
Joints are filled and compacted, the surface is cleaned, and we walk the finished work with you.
Questions
What Thousand Oaks Homeowners Ask
Who issues the permits for this work in Thousand Oaks?
City of Thousand Oaks Community Development Department, Building Division. Residential permits are issued by the Building Division of the City's Community Development Department. Thousand Oaks protects all Quercus species over two inches in diameter, and the protected zone reaches five feet beyond the outer canopy or fifteen feet from the trunk, whichever is greater, so work or soil disturbance inside that zone requires an oak tree permit.
Hillside Planned Development zoning and the Protected Ridgeline and Height Limit overlay zones apply area by area and add grading, siting and visual-analysis requirements. Review length varies with the extent of tree and grading review a project triggers.
We prepare the drawings, make the submittal and handle plan-check corrections ourselves, so you are not the one chasing plan check.
What makes building in Thousand Oaks different?
A wide range, from flat suburban parcels with generous rear yards in the older tracts to larger hillside and gated-community lots with slope, oaks and protected view corridors in North Ranch, Sunset Hills and Dos Vientos. One local condition that shapes the work: Volcanic and sedimentary bedrock sits close to grade on many hillside parcels, so pool and spa excavation can become rock removal with a very different cost and schedule.
Which parts of Thousand Oaks do you work in?
All of it, including North Ranch, Wildwood, Sunset Hills and Dos Vientos Ranch. Our crews run every job out of our Cahuenga Pass base in Los Angeles, with our own people on site.
What does a paver or hardscape project cost in Thousand Oaks?
Paver patio and hardscape: generally from about $13,000 across Southern California. What moves it is square footage, paver type, base preparation, drainage, and any steps or retaining involved. We give line-item pricing after seeing the site rather than quoting a number over the phone.
How long does a paver project take?
Most paver patios and walkways take three to six weeks of construction. Driveways, retaining walls and drainage work add time, and so does demolition of thick existing concrete.
Do pavers need a permit?
A patio on grade usually does not. Retaining walls above a certain height, a driveway approach at the street and work that changes drainage often do, and the thresholds differ by city. We check with your building department before we price the job.
Can you pave over my existing concrete?
Sometimes, with thin pavers made for overlays, if the slab is sound and the added height works at doors and steps. A cracked or sinking slab should come out, because the pavers will follow whatever is under them.
How do I look after pavers?
Very little is needed. Sweep them, rinse them, and top up the joint sand if it washes out over the years. If one paver stains or settles it can be lifted and reset, which is the main advantage over poured concrete.
More Services in Thousand Oaks
Planning Guides
Before You Build in Thousand Oaks
Costs, materials and process notes from our own projects.
Backyard Remodeling in Thousand Oaks: Conejo Valley Living
Thousand Oaks offers ideal conditions for outdoor living with moderate temperatures and stunning foothill views. Here's your complete guide.
Read guideDriveway Design Ideas for California Homes
Your driveway is the first impression of your home. Explore modern driveway designs, materials, and patterns that elevate California curb appeal.
Read guideWhy Base Preparation Matters for Hardscape Projects
The base beneath your pavers determines whether they last 5 years or 50. Learn why proper base preparation is the most important part of any hardscape project.
Read guideOutdoor Stair Design: Safe and Beautiful Grade Changes
Outdoor stairs connect different levels of your landscape while adding architectural interest. Learn about materials, code requirements, and design options.
Read guidePlanning Pavers in Thousand Oaks?
Sit down with your project manager and get an accurate estimate. We call you back within one business day.
Licensed, bonded & insured · CSLB license #1119054