
Pool & Spa Remodeling in Corona
New pools, spa additions, replastering, tile and coping, and full pool remodels. Designed, permitted and built by our own crews.
Pool & Spa Remodeling built for Corona properties
Corona grew up around a circle. Civil engineer H.C. Kellogg turned founder R.B. Taylor's idea of a grand circular boulevard into Grand Boulevard, with a grid of streets enclosed inside it, and the loop hosted the Corona Road Races between 1913 and 1916, by which time the town was already known as the Lemon Capital of the World. The city has since added more than thirty specific plans, from Sierra Del Oro and Corona Ranch to Eagle Glen and Dos Lagos. On a backyard here the deciding questions are slope position, where the pool equipment can legally sit, and whether the parcel falls in a mapped fire hazard zone.
Two broad patterns: the original grid of streets enclosed by Grand Boulevard, and the later specific-plan communities, where development standards are set plan by plan. Slope position and fire hazard mapping vary from lot to lot, so both are checked before design starts.
We are a design-build team, which means the people who draw your project are the people who build it. Design, engineering, permits and construction run through one project manager and our own crews, so nothing gets lost in a handoff between a salesperson and a subcontractor. We are licensed and insured, CSLB license #1119054.
Permits in Corona: The Building Division is one of four divisions in the Planning & Development Department, alongside Planning, Code Compliance and Development Services, and works from 400 South Vicentia Avenue on a Monday-through-Thursday schedule, closed Fridays. Plans are submitted and tracked through the city's eTRAKiT portal. The division's pool advisory requires Development Services and Planning approval before a pool goes to building plan check, structural plans prepared and stamped by a licensed architect or engineer, and a soils report wherever the Building Official calls for one; barbecue islands that include a sink also require plan review. Chapter 7A ignition-resistant construction applies in the mapped Very High Fire Hazard Severity Zone, the city's 2025 map update extends that standard to High zones once adopted, and applicants are asked to verify a parcel's zone before plan check.
Permit details checked September 2026 against City of Corona. Rules change, so we confirm them again for your parcel.
What We Build
- Top-of-slope pool setback engineering
- Equipment placement and sound wall detailing
- Chapter 7A ignition-resistant specification
- New gunite pool and spa construction
- Full pool remodels and replastering
- Pebble, quartz and plaster interior finishes
- Waterline tile and coping replacement
- Raised and attached spas with spillways
- Baja shelves, benches and sun ledges
- Water features, fire bowls and sheer descents
- Equipment upgrades, heaters and automation
- Pool decking in pavers, concrete or travertine
- LED lighting and salt-water conversions
Local Conditions
What building in Corona actually involves
Every city in Southern California builds differently. These are the things that change the scope, the schedule or the budget on Corona projects.
A pool shell closer than seven feet to the top of a slope must be engineered to hold its water without soil support, and near the toe of a slope steeper than one in three the setback is a quarter of the slope height, so slope position often decides where a pool can sit.
Pumps and filters must stand at least ten feet from an adjoining property line unless a block wall at least five feet high, extending two feet past the equipment on each side, separates them from the neighbor, which drives equipment pad and sound wall placement.
Roughly 3,000 structures sit inside the city's Very High Fire Hazard Severity Zone and just over 14,000 more lie within half a mile of it, so venting, decking and cladding choices near the wildland edge are made with ember exposure in mind.
Staging sand or materials in the street during a pool build requires an encroachment permit from Development Services, and draining a pool or backwash to the sewer through a P-trap is prohibited without Utilities Department approval, so logistics and discharge are planned before excavation.
Investment
What this costs in Corona
Real Southern California ranges, not a teaser number. Every project is priced line by line after we have seen the site.
New pool construction
$70,000 to $150,000+
What moves it: size and shape, spa, water and fire features, decking material, automation, and how much access and grading the site needs
Pool remodel and resurfacing
$15,000 to $45,000
What moves it: finish choice (plaster versus pebble or quartz), tile and coping replacement, new equipment, and whether the deck is being replaced at the same time
Paver patio and hardscape
from about $13,000
What moves it: square footage, paver type, base preparation, drainage, and any steps or retaining involved
Your number depends on your lot, your access and your finishes. We walk the site, then price every line so you can see exactly where the budget goes.
Get a line-item price for your Corona propertyHow We Build
Your Corona project, step by step
Site Review
We walk the property, check access, soil and slope, and confirm what the yard can actually take.
Design & 3D
You see the pool in 3D before anything is dug, with finishes, tile and decking chosen.
Plans & Permits
We draw the plans, handle engineering where the site needs it, and pull the permits. In Corona that submittal goes to City of Corona Planning & Development Department, Building Division.
Excavation & Shell
Dig, steel, plumbing and gunite. This is where site access and grading matter most.
Finishes
Tile, coping, decking and your chosen interior finish go in.
Startup & Handover
We fill, balance the water, commission the equipment and walk you through every control.
Corona Questions
Common questions from Corona homeowners
Who issues the permits for this work in Corona?
City of Corona Planning & Development Department, Building Division. The Building Division is one of four divisions in the Planning & Development Department, alongside Planning, Code Compliance and Development Services, and works from 400 South Vicentia Avenue on a Monday-through-Thursday schedule, closed Fridays. Plans are submitted and tracked through the city's eTRAKiT portal. The division's pool advisory requires Development Services and Planning approval before a pool goes to building plan check, structural plans prepared and stamped by a licensed architect or engineer, and a soils report wherever the Building Official calls for one; barbecue islands that include a sink also require plan review. Chapter 7A ignition-resistant construction applies in the mapped Very High Fire Hazard Severity Zone, the city's 2025 map update extends that standard to High zones once adopted, and applicants are asked to verify a parcel's zone before plan check. We prepare the drawings, make the submittal and handle plan-check corrections ourselves, so you are not the one chasing plan check.
What makes building in Corona different?
Two broad patterns: the original grid of streets enclosed by Grand Boulevard, and the later specific-plan communities, where development standards are set plan by plan. Slope position and fire hazard mapping vary from lot to lot, so both are checked before design starts. One local condition that shapes the work: A pool shell closer than seven feet to the top of a slope must be engineered to hold its water without soil support, and near the toe of a slope steeper than one in three the setback is a quarter of the slope height, so slope position often decides where a pool can sit.
Which parts of Corona do you work in?
All of it, including Sierra Del Oro, Corona Ranch, Mountain Gate and Eagle Glen. Our crews run every job out of our Cahuenga Pass base in Los Angeles, with our own people on site.
What does a pool or spa project cost in Corona?
New pool construction: generally $70,000 to $150,000+ across Southern California. What moves it is size and shape, spa, water and fire features, decking material, automation, and how much access and grading the site needs. We give line-item pricing after seeing the site rather than quoting a number over the phone.
How long does a pool remodel take?
A straightforward replaster with new tile and coping usually runs three to five weeks. A full remodel that includes new decking, equipment and features typically runs eight to twelve weeks. Site access and permit timing are the two things that move that most.
How long does a new pool take to build?
Most new pool builds run about three to five months from permit to first swim. Hillside sites that need engineered retaining or difficult access sit at the longer end of that range.
Should I replaster or fully remodel?
If the shell and plumbing are sound and you only dislike the surface, replastering with new tile and coping is the efficient choice. If the equipment is aging, the deck is cracked or the shape no longer suits how you use the yard, a full remodel costs less than doing it in two separate phases.
Do you self-perform the work?
Yes. Our own crews handle the build rather than passing it to a rotating set of subs, which is why the schedule and the finish standard stay consistent.
More services in Corona
Pool & Spa Remodeling nearby
Corona Guides
Planning guides for Corona homeowners
Costs, materials and process notes from our own projects.
Outdoor Kitchens in Corona: Design for Hot Weather Entertaining
Corona's hot summers require outdoor kitchens designed for heat management. Here's how to build for comfort and durability.
Read guideBuilding a Pool in Northridge: Costs, Soil and the LADBS Process
A new pool in Northridge typically runs $85,000 to $165,000 all-in with decking and equipment. The tract lots are generous, the soil is workable, and the real variables are access, spa and deck square footage.
Read guideVan Nuys Pool and Backyard Guide: Costs on the Valley Floor
A new pool in Van Nuys runs $75,000 to $145,000, and a pool-plus-backyard package $110,000 to $220,000. Flat lots keep excavation honest; older service panels and gas meters are where budgets slip.
Read guideTravertine vs Porcelain Pavers: The Honest Comparison for SoCal Yards
Travertine installs at roughly $22 to $30 per square foot, porcelain at $24 to $34. The real difference is heat, staining and how each one handles a chlorinated pool deck over ten years.
Read guidePlanning a pool or spa project in Corona?
Sit down with your project manager, go through the details, and get an accurate estimate for your property. We call you back within one business day.
Licensed & insured · CSLB license #1119054