Skip to main content
Lit board-formed concrete retaining wall and steps on a hillside
Design · Permit · Build

Paver & Hardscape Contractor in Los Angeles

Paver patios, driveways and walls, built on a proper base by our own crews.

Licensed contractor
California general contractor, CSLB #1119054. Bonded and insured.
Typical cost
Paver patio and hardscape: from about $13,000.
Permits
Issued by LADBS. We handle the plans and the submittal.

Built for Los Angeles Homes

We work across the City of Los Angeles, and the practical reality is that two addresses ten minutes apart can sit under completely different rule sets. One parcel is flat R1 with a straightforward pool permit; the next is inside a hillside area, a methane zone, an HPOZ, or a very high fire hazard severity zone.

Our first move on any Los Angeles project is pulling the parcel's zoning and hazard overlays before a single line gets drawn.

Lot character varies enormously, from 5,000-square-foot flat R1 parcels in the older grid neighborhoods to steep, irregular hillside lots where usable outdoor space has to be manufactured with retaining structures and cantilevered decking.

What to Plan For

Pavers last when the base is right. What you see is the top two or three inches. Underneath is excavation to the correct depth, a compacted base, a setting bed and an edge restraint that stops the field from spreading. That work is where a paver job is won or lost, and it is the part a low bid leaves out.

Water comes next. Hardscape changes where rain goes, so we set the slopes and add drains while the ground is open. Fixing drainage after the pavers are down means lifting them again.

The material is your choice. Concrete pavers, porcelain and natural stone such as travertine differ in look, in how hot they get underfoot and in price. A driveway needs a thicker paver and a deeper base than a patio. We bring samples and show the layout in 3D, so the pattern and the borders are settled before we order.

We are a design-build team, which means the people who draw your project are the people who build it. Design, engineering, permits and construction run through one project manager and our own crews, so nothing gets lost in a handoff between a salesperson and a subcontractor. We are licensed, bonded and insured, CSLB license #1119054.

Permits in Los Angeles: LADBS issues residential building, grading, plumbing, electrical and pool permits citywide, with Development Services Centers downtown and in Van Nuys, West Los Angeles, South Los Angeles and San Pedro, while zoning entitlements and design review come from Los Angeles City Planning.

Parcels in a designated hillside area fall under the Baseline Hillside Ordinance (No. 184,802), which limits residential floor area, building envelope height, and grading and import/export quantities. Protected trees and shrubs (native oaks other than scrub oak, western sycamore, Southern California black walnut, California bay, Mexican elderberry and toyon) are regulated under LAMC 46.00 at four inches of cumulative trunk diameter, and removing or relocating one needs a StreetsLA Urban Forestry Division permit. Review length varies by parcel and scope.

Permit details checked September 2026 against LADBS. Rules change, so we confirm them again for your parcel.

What We Build

  • Hillside pool and retaining structure engineering
  • Methane mitigation coordination where zoned
  • Protected-tree permitting through Urban Forestry
  • Paver patios and pool decks
  • Paver driveways and walkways
  • Concrete, porcelain and natural stone pavers
  • Excavation, compacted base and edge restraint
  • Drainage correction and grading
  • Retaining walls and seat walls
  • Steps, landings and planters
  • Fire pits with built-in seating
  • Artificial turf and turf joints
  • Low-voltage hardscape lighting

Local Conditions

What to Know in Los Angeles

These local conditions change the scope, the schedule and the budget.

01

Soil swings from deep alluvial fill on the valley floors to weathered bedrock and old landslide debris in the hills, so the geotechnical report drives foundation and pool shell design more than the architecture does.

02

Older neighborhoods still carry 100-amp services, clay sewer laterals and galvanized supply lines that must be upgraded before a pool, spa heater and outdoor kitchen can be added.

03

Many pre-1940 parcels have a detached rear garage off an alley, and that alley is often the only viable equipment path, deciding whether excavation is machine work or conveyor and hand work.

04

Hillside streets are narrow and frequently lack turnarounds, so staging for concrete, gunite and crane picks has to be planned around fire access requirements and neighbors.

Areas we serve in Los Angeles:Hancock ParkLos FelizSilver LakeCheviot HillsWindsor SquareMount Washington

Investment

What It Costs in Los Angeles

Real Southern California price ranges, not teaser numbers.

Paver patio and hardscape

from about $13,000

What moves it: square footage, paver type, base preparation, drainage, and any steps or retaining involved

Retaining walls

$60 to $150 per face foot

What moves it: height, whether the wall is engineered, material choice, drainage behind the wall, and access for equipment and materials

Artificial turf

from about $9,900

What moves it: area, turf grade, base depth, drainage, and any pet-specific infill

Your lot, access and finishes set the price. We walk the site, then show you where every dollar goes.

Get a line-item price for your Los Angeles property

The Process

How We Work in Los Angeles

01

Site Review

We measure the area, check soil, slope and drainage, and note access for equipment and materials.

02

Design & 3D

You see the layout, pattern, borders and material in 3D before anything is ordered.

03

Plans & Permits

Walls, driveway approaches and drainage work are drawn and permitted where your city requires it. In Los Angeles that submittal goes to Los Angeles Department of Building and Safety (LADBS).

04

Demo & Excavation

Old concrete comes out and the area is dug to the depth the new base needs.

05

Base & Pavers

Base is placed and compacted in layers, then the setting bed, pavers, cuts and edge restraint.

06

Joints & Handover

Joints are filled and compacted, the surface is cleaned, and we walk the finished work with you.

Questions

What Los Angeles Homeowners Ask

Who issues the permits for this work in Los Angeles?

Los Angeles Department of Building and Safety (LADBS). LADBS issues residential building, grading, plumbing, electrical and pool permits citywide, with Development Services Centers downtown and in Van Nuys, West Los Angeles, South Los Angeles and San Pedro, while zoning entitlements and design review come from Los Angeles City Planning.

Parcels in a designated hillside area fall under the Baseline Hillside Ordinance (No. 184,802), which limits residential floor area, building envelope height, and grading and import/export quantities. Protected trees and shrubs (native oaks other than scrub oak, western sycamore, Southern California black walnut, California bay, Mexican elderberry and toyon) are regulated under LAMC 46.00 at four inches of cumulative trunk diameter, and removing or relocating one needs a StreetsLA Urban Forestry Division permit.

Review length varies by parcel and scope. We prepare the drawings, make the submittal and handle plan-check corrections ourselves, so you are not the one chasing plan check.

What makes building in Los Angeles different?

Lot character varies enormously, from 5,000-square-foot flat R1 parcels in the older grid neighborhoods to steep, irregular hillside lots where usable outdoor space has to be manufactured with retaining structures and cantilevered decking. One local condition that shapes the work: Soil swings from deep alluvial fill on the valley floors to weathered bedrock and old landslide debris in the hills, so the geotechnical report drives foundation and pool shell design more than the architecture does.

Which parts of Los Angeles do you work in?

All of it, including Hancock Park, Los Feliz, Silver Lake and Cheviot Hills. Our crews run every job out of our Cahuenga Pass base in Los Angeles, with our own people on site.

What does a paver or hardscape project cost in Los Angeles?

Paver patio and hardscape: generally from about $13,000 across Southern California. What moves it is square footage, paver type, base preparation, drainage, and any steps or retaining involved. We give line-item pricing after seeing the site rather than quoting a number over the phone.

How long does a paver project take?

Most paver patios and walkways take three to six weeks of construction. Driveways, retaining walls and drainage work add time, and so does demolition of thick existing concrete.

Do pavers need a permit?

A patio on grade usually does not. Retaining walls above a certain height, a driveway approach at the street and work that changes drainage often do, and the thresholds differ by city. We check with your building department before we price the job.

Can you pave over my existing concrete?

Sometimes, with thin pavers made for overlays, if the slab is sound and the added height works at doors and steps. A cracked or sinking slab should come out, because the pavers will follow whatever is under them.

How do I look after pavers?

Very little is needed. Sweep them, rinse them, and top up the joint sand if it washes out over the years. If one paver stains or settles it can be lifted and reset, which is the main advantage over poured concrete.

Planning Pavers in Los Angeles?

Sit down with your project manager and get an accurate estimate. We call you back within one business day.

Licensed, bonded & insured · CSLB license #1119054