
Paver & Hardscape Contractor in Venice
Paver patios, driveways and walls, built on a proper base by our own crews.
- Licensed contractor
- California general contractor, CSLB #1119054. Bonded and insured.
- Typical cost
- Paver patio and hardscape: from about $13,000.
- Permits
- Issued by LADBS. We handle the plans and the submittal.
Built for Venice Homes
Groundwater is the first thing we look at. Near the canals and the beach, groundwater can sit shallow enough to reach a pool excavation, which means dewatering, hydrostatic relief and a heavier shell than the drawings first suggest. Narrow walk-street and canal lots rarely take a truck, so material moves by hand or over the roof by crane. On top of all that, almost every parcel needs a coastal permit before a shovel moves.
Unusually narrow lots on walk streets, canals and alley-loaded blocks, with small deep rear yards and minimal street frontage.
What to Plan For
Pavers last when the base is right. What you see is the top two or three inches. Underneath is excavation to the correct depth, a compacted base, a setting bed and an edge restraint that stops the field from spreading. That work is where a paver job is won or lost, and it is the part a low bid leaves out.
Water comes next. Hardscape changes where rain goes, so we set the slopes and add drains while the ground is open. Fixing drainage after the pavers are down means lifting them again.
The material is your choice. Concrete pavers, porcelain and natural stone such as travertine differ in look, in how hot they get underfoot and in price. A driveway needs a thicker paver and a deeper base than a patio. We bring samples and show the layout in 3D, so the pattern and the borders are settled before we order.
We are a design-build team, which means the people who draw your project are the people who build it. Design, engineering, permits and construction run through one project manager and our own crews, so nothing gets lost in a handoff between a salesperson and a subcontractor. We are licensed, bonded and insured, CSLB license #1119054.
Permits in Venice: Building, grading and pool permits are issued by LADBS because this is part of the City of Los Angeles, but nearly the whole community sits inside the coastal zone. The Venice Local Coastal Program is still not fully certified (a Land Use Plan certified in 2001 is in place while an updated plan is being drafted with the California Coastal Commission) so projects need a coastal development permit through Los Angeles City Planning, and city decisions remain appealable to the Commission.
Most projects also require a Venice Coastal Zone Specific Plan (Ordinance No. 175,693) determination or specific plan exemption before a building permit can be issued. In the mapped dual permit jurisdiction area a separate Coastal Commission permit is required as well, so entitlement duration varies widely.
Permit details checked September 2026 against LADBS, LA City Planning and State of California. Rules change, so we confirm them again for your parcel.
What We Build
- High water table pool engineering and dewatering
- Coastal development permit and specific plan clearance
- Crane and conveyor material handling on no-access lots
- Paver patios and pool decks
- Paver driveways and walkways
- Concrete, porcelain and natural stone pavers
- Excavation, compacted base and edge restraint
- Drainage correction and grading
- Retaining walls and seat walls
- Steps, landings and planters
- Fire pits with built-in seating
- Artificial turf and turf joints
- Low-voltage hardscape lighting
Local Conditions
What to Know in Venice
These local conditions change the scope, the schedule and the budget.
Groundwater near the canals and the beach can be shallow, which can require dewatering during excavation and hydrostatic relief in the finished pool shell.
Sandy fill mapped for liquefaction pushes pool and foundation design toward deeper structural solutions than the same project would need a few miles inland.
Narrow walk-street and canal lots have no direct vehicle access, so excavated soil, gunite and hardscape material move by conveyor, buggy or crane over the roofline.
Salt-laden air and blowing sand shorten the life of untreated metal, so equipment enclosures, fasteners and outdoor kitchen components are specified for that exposure.
Investment
What It Costs in Venice
Real Southern California price ranges, not teaser numbers.
Paver patio and hardscape
from about $13,000
What moves it: square footage, paver type, base preparation, drainage, and any steps or retaining involved
Retaining walls
$60 to $150 per face foot
What moves it: height, whether the wall is engineered, material choice, drainage behind the wall, and access for equipment and materials
Artificial turf
from about $9,900
What moves it: area, turf grade, base depth, drainage, and any pet-specific infill
Your lot, access and finishes set the price. We walk the site, then show you where every dollar goes.
Get a line-item price for your Venice propertyThe Process
How We Work in Venice
Site Review
We measure the area, check soil, slope and drainage, and note access for equipment and materials.
Design & 3D
You see the layout, pattern, borders and material in 3D before anything is ordered.
Plans & Permits
Walls, driveway approaches and drainage work are drawn and permitted where your city requires it. In Venice that submittal goes to Los Angeles Department of Building and Safety (LADBS).
Demo & Excavation
Old concrete comes out and the area is dug to the depth the new base needs.
Base & Pavers
Base is placed and compacted in layers, then the setting bed, pavers, cuts and edge restraint.
Joints & Handover
Joints are filled and compacted, the surface is cleaned, and we walk the finished work with you.
Questions
What Venice Homeowners Ask
Who issues the permits for this work in Venice?
Los Angeles Department of Building and Safety (LADBS). Building, grading and pool permits are issued by LADBS because this is part of the City of Los Angeles, but nearly the whole community sits inside the coastal zone. The Venice Local Coastal Program is still not fully certified (a Land Use Plan certified in 2001 is in place while an updated plan is being drafted with the California Coastal Commission) so projects need a coastal development permit through Los Angeles City Planning, and city decisions remain appealable to the Commission.
Most projects also require a Venice Coastal Zone Specific Plan (Ordinance No. 175,693) determination or specific plan exemption before a building permit can be issued. In the mapped dual permit jurisdiction area a separate Coastal Commission permit is required as well, so entitlement duration varies widely.
We prepare the drawings, make the submittal and handle plan-check corrections ourselves, so you are not the one chasing plan check.
What makes building in Venice different?
Unusually narrow lots on walk streets, canals and alley-loaded blocks, with small deep rear yards and minimal street frontage. One local condition that shapes the work: Groundwater near the canals and the beach can be shallow, which can require dewatering during excavation and hydrostatic relief in the finished pool shell.
Which parts of Venice do you work in?
All of it, including The Venice Canals, Oakwood, Milwood and East Venice. Our crews run every job out of our Cahuenga Pass base in Los Angeles, with our own people on site.
What does a paver or hardscape project cost in Venice?
Paver patio and hardscape: generally from about $13,000 across Southern California. What moves it is square footage, paver type, base preparation, drainage, and any steps or retaining involved. We give line-item pricing after seeing the site rather than quoting a number over the phone.
How long does a paver project take?
Most paver patios and walkways take three to six weeks of construction. Driveways, retaining walls and drainage work add time, and so does demolition of thick existing concrete.
Do pavers need a permit?
A patio on grade usually does not. Retaining walls above a certain height, a driveway approach at the street and work that changes drainage often do, and the thresholds differ by city. We check with your building department before we price the job.
Can you pave over my existing concrete?
Sometimes, with thin pavers made for overlays, if the slab is sound and the added height works at doors and steps. A cracked or sinking slab should come out, because the pavers will follow whatever is under them.
How do I look after pavers?
Very little is needed. Sweep them, rinse them, and top up the joint sand if it washes out over the years. If one paver stains or settles it can be lifted and reset, which is the main advantage over poured concrete.
More Services in Venice
Pavers & Hardscape Nearby
Planning Guides
Before You Build in Venice
Costs, materials and process notes from our own projects.
ADU Design Ideas for Los Angeles Neighborhoods
Los Angeles neighborhoods have distinct characters that should inform ADU design. Explore ideas for ADUs that complement homes in Silver Lake, Venice, the Valley, and beyond.
Read guideDriveway Design Ideas for California Homes
Your driveway is the first impression of your home. Explore modern driveway designs, materials, and patterns that elevate California curb appeal.
Read guideWhy Base Preparation Matters for Hardscape Projects
The base beneath your pavers determines whether they last 5 years or 50. Learn why proper base preparation is the most important part of any hardscape project.
Read guideOutdoor Stair Design: Safe and Beautiful Grade Changes
Outdoor stairs connect different levels of your landscape while adding architectural interest. Learn about materials, code requirements, and design options.
Read guidePlanning Pavers in Venice?
Sit down with your project manager and get an accurate estimate. We call you back within one business day.
Licensed, bonded & insured · CSLB license #1119054