Skip to main content
Covered patio with a linear fire table and lounge seating
Design · Permit · Build

Patio Cover & Pergola Contractor in South Pasadena

Patio covers and pergolas, engineered, permitted and built by our own crews.

Licensed contractor
California general contractor, CSLB #1119054. Bonded and insured.
Typical cost
Pergola and shade structure: from about $9,500.
Permits
Issued by the City of South Pasadena. We handle the plans and the submittal.

Built for South Pasadena Homes

South Pasadena is a small city that takes its architecture seriously, and we plan for that from the first sketch. Much of what we touch here is a century old, so we treat the existing house as a design constraint rather than a blank slate. Our scopes account for historic review, protected oaks, tight rear-alley access, and electrical systems that were never sized for a pool heater or a detached studio.

Most parcels are modest by San Gabriel Valley standards: long, narrow lots with generous street trees and detached garages set at the rear. Hillside neighborhoods trade flat yard for slope and view.

What to Plan For

A patio cover is a structure, and it is designed like one. Attached to the house, it has to tie into the existing framing properly. Freestanding, it stands on its own footings. Either way the span, the posts and the footings are sized for the roof it carries, and that is what a building department reviews.

The roof decides how the space gets used. An open pergola filters the sun and keeps the sky. A solid roof gives real shade and shelter from rain. A louvered roof opens and closes, so you can have both. Wood, aluminum and steel each look and age differently, and we show you the options in 3D against your own house.

It is rarely built alone. Lighting, fans and heaters need power run to the structure, and the patio underneath often gets rebuilt at the same time. Planning them as one project means the posts land where the paving and the furniture want them.

We are a design-build team, which means the people who draw your project are the people who build it. Design, engineering, permits and construction run through one project manager and our own crews, so nothing gets lost in a handoff between a salesperson and a subcontractor. We are licensed, bonded and insured, CSLB license #1119054.

Permits in South Pasadena: Residential permits come from the Building Division of the Community Development Department, with entitlements handled by the Planning Division in that same department. Because so much of the housing stock is historic, alterations, additions, and demolitions affecting designated resources go before the Cultural Heritage Commission for a Certificate of Appropriateness.

The city's tree ordinance protects all oak species and other mature protected trees, requiring a removal permit and replacement planting, with steep fines for unpermitted removal. The Raymond Fault Alquist-Priolo Earthquake Fault Zone crosses the city.

State law exempts most individual one- and two-story wood-frame single-family homes from its fault-study requirement, but cities can set stricter rules, so we check parcels inside the zone early.

Permit details checked September 2026 against City of South Pasadena, South Pasadena Municipal Code and State of California. Rules change, so we confirm them again for your parcel.

What We Build

  • Cultural Heritage Commission submittals
  • Rear-alley ADU and pool access planning
  • Service and sewer lateral upgrades
  • Attached patio covers
  • Freestanding pergolas and pavilions
  • Louvered roof systems
  • Solid roof covers
  • Wood, aluminum and steel structures
  • Engineered posts, beams and footings
  • Lighting, fans and heaters, wired in
  • Covers over outdoor kitchens and dining
  • Paver or concrete patios beneath
  • Plans, engineering and permits

Local Conditions

What to Know in South Pasadena

These local conditions change the scope, the schedule and the budget.

01

Hillside tracts on the southwest side climb quickly, so pools and outdoor rooms there usually need retaining walls, pier-supported decks, and engineered drainage rather than simple flat-yard construction.

02

Craftsman and Victorian houses commonly sit on shallow unreinforced foundations with knob-and-tube remnants and undersized panels, so pool equipment and detached-unit loads usually force a service upgrade.

03

Deep, narrow lots with rear alleys are common, which favors detached ADUs but limits excavator size and often means conveyor or crane access for gunite.

04

Original clay sewer laterals under mature parkway trees are frequently root-intruded, and they get discovered during trenching for new backyard structures.

Areas we serve in South Pasadena:Altos de MontereyMission WestGarfield ParkRaymond Hill

Investment

What It Costs in South Pasadena

Real Southern California price ranges, not teaser numbers.

Pergola and shade structure

from about $9,500

What moves it: span, material (wood, aluminum or louvered), footing requirements, and integrated lighting or heating

Paver patio and hardscape

from about $13,000

What moves it: square footage, paver type, base preparation, drainage, and any steps or retaining involved

Landscape and architectural lighting

$3,000 to $12,000

What moves it: number of fixtures, transformer and cable runs, fixture quality, and whether the system is put on smart control

Your lot, access and finishes set the price. We walk the site, then show you where every dollar goes.

Get a line-item price for your South Pasadena property

The Process

How We Work in South Pasadena

01

Site Review

We measure the patio and the house, check where posts and footings can go, and note sun and sight lines.

02

Design & 3D

You see the cover in 3D on your own house, open, solid or louvered, in the material you choose.

03

Plans & Permits

The structure is drawn and engineered, and submitted for a permit where your city requires one. In South Pasadena that submittal goes to City of South Pasadena Community Development Department, Building Division.

04

Footings & Posts

Footings are dug and poured, then posts are set plumb and anchored.

05

Frame & Roof

Beams, rafters and the roof system go on, with power run for lighting, fans and heaters.

06

Finish & Handover

Stain, paint or powder coat, final electrical, inspection where one applies, and a walkthrough.

Questions

What South Pasadena Homeowners Ask

Who issues the permits for this work in South Pasadena?

City of South Pasadena Community Development Department, Building Division. Residential permits come from the Building Division of the Community Development Department, with entitlements handled by the Planning Division in that same department.

Because so much of the housing stock is historic, alterations, additions, and demolitions affecting designated resources go before the Cultural Heritage Commission for a Certificate of Appropriateness. The city's tree ordinance protects all oak species and other mature protected trees, requiring a removal permit and replacement planting, with steep fines for unpermitted removal.

The Raymond Fault Alquist-Priolo Earthquake Fault Zone crosses the city. State law exempts most individual one- and two-story wood-frame single-family homes from its fault-study requirement, but cities can set stricter rules, so we check parcels inside the zone early.

We prepare the drawings, make the submittal and handle plan-check corrections ourselves, so you are not the one chasing plan check.

What makes building in South Pasadena different?

Most parcels are modest by San Gabriel Valley standards: long, narrow lots with generous street trees and detached garages set at the rear. Hillside neighborhoods trade flat yard for slope and view. One local condition that shapes the work: Hillside tracts on the southwest side climb quickly, so pools and outdoor rooms there usually need retaining walls, pier-supported decks, and engineered drainage rather than simple flat-yard construction.

Which parts of South Pasadena do you work in?

All of it, including Altos de Monterey, Mission West, Garfield Park and Raymond Hill. Our crews run every job out of our Cahuenga Pass base in Los Angeles, with our own people on site.

What does a patio cover or pergola cost in South Pasadena?

Pergola and shade structure: generally from about $9,500 across Southern California. What moves it is span, material (wood, aluminum or louvered), footing requirements, and integrated lighting or heating. We give line-item pricing after seeing the site rather than quoting a number over the phone.

Do I need a permit for a patio cover or pergola?

Usually yes for a cover attached to the house or one with a solid roof. Small freestanding pergolas are treated differently from city to city, and adding electrical brings its own permit. We check the rule with your building department before we price the job.

Wood, aluminum or a louvered roof?

Wood is warm and can be shaped to match almost any house, and it needs refinishing over the years. Aluminum needs very little upkeep and suits a clean, modern look. A louvered roof costs more and lets you open the space to the sky or close it for shade and rain.

Can it have lights, a fan and heaters?

Yes. They are far cleaner to add when they are planned, because the wiring runs inside the posts and beams. Adding them later usually means surface conduit.

How long does a patio cover take?

The build itself is short compared with the planning. Engineering and the plan review in your city usually set the schedule, so we give you a real timeline once we know which review your project needs.

Planning a Patio Cover in South Pasadena?

Sit down with your project manager and get an accurate estimate. We call you back within one business day.

Licensed, bonded & insured · CSLB license #1119054